Available by Request For Quote.
Welcome to Fabricor Products, Inc. We are a full fabrication job shop specializing in custom metal spinning, stamping and cnc plasma cutting. This page contains a very small representation of the metals, diameter and thickness of metals we can provide. See our “capabilities” section which has our standard blanking die size matrix listed.
This page contains a small sampling of blanks we can provide. We have full machining capabilities and can make complete products including powder coating at our facility.
We manufacture or stock blanks from Aluminum (1100, 6061), Brass (260), Copper (110) Cold Roll Steel, Hot Roll Steel, Galvanized Steel and Stainless Steel (304-2b) in almost any size and thicknesses to 1/8″. We typically stock from .025″ to .063″ for stamped round blanks and/or fabricated squares. We go up to ¼″ using other methods such as circle shear, square shear or plasma cutting along with the ability to machine thicker rounds. We can put almost any size round hole in the blanks centered, indexed pattern or random as needed. We can also make special holes by a variety of methods. Contact us for quotation on materials not shown.
This is just a minimum amount of items we are capable of manufacturing, including some 18 gauge (approx. .047″) cold roll steel round blanks with 13/32″ center holes; these are blanked from a punch press and will have a minor burr. We also can offer 11 gauge (approx. 0.119″) hot roll steel disks with no holes; these are made by CNC Plasma cutting method. Any of the shown parts can be ordered special with any size holes or without holes.
Our CNC Plasma cutting method can provide you with round or any other shapes from ¼″ thick hot roll steel down to 22 gauge (approx. .027″) cold roll. Limitations are mostly for consideration of pierce points and kerf width. This method will also cut copper, brass, aluminum and stainless steel. The finish on the edges of plasma cut parts generally are not smooth and will have some bevel to the edge. This method is excellent for the rustic hand made look, where edge appearance does not matter or the edges will be finished later. These are by RFQ.
Punch pressed blanks are typically made from .020″ thick to .063″ and some thicker materials from aluminum, brass, copper, steel, stainless steel. Some thicker materials can be handled with some die modification, our presses go to 75 ton. Center holes can be stamped from an extensive set of small die sets or drilled. We have a complete list of standard dies for the outside dimensions from 2″ to 6″ by 1/8″ increments listed on our capabilities page.
Circle sheared blanks can be made up to 47″ diameter 3/16″ thick from soft steel or equivalent material. Any other requirements, please inquire.
We can make any size, other thickness or holes by RFQ - see our Capabilities page.
18GA CRS Washers/Blanks
ROUND WASHERS COLD ROLL STEEL, 18GA CRS, 13/32 CENTER HOLE (1/8 IPS). 2″ through 3 7/8″ by 1/8″ increments Stamped.
11GA Square Blanks/Plates
SQUARE BLANK/PLATE HOT ROLL STEEL, 11GA. 4″ through 12″ by 1″ increments Plasma Cut.
11GA Round Disks
ROUND BLANK/DISK, HOT ROLL STEEL, 11GA. 4″ through 12″ by 1″ increments Plasma Cut.